The small plastic parts holding your car's critical wiring firmly together are efficiently produced by the absolute millions every single week, but the factory creation process is actually incredibly precise and totally fascinating. The manufacturing journey begins entirely with tiny, raw plastic pellets, usually a highly durable chemical blend like Polybutylene Terephthalate. These incredibly hard pellets are dumped forcefully into a massive, heavily heated hopper on an industrial injection molding machine. Deep inside the heavy machine, a giant spinning steel screw completely melts the plastic down into a very thick, boiling hot liquid state. Once the material fully reaches the absolutely perfect temperature and liquid consistency, a massive hydraulic ram forces the hot liquid plastic under immense, crushing pressure into a freezing cold, custom-cut solid steel mold.
Inside this incredibly heavy steel mold, the pressurized hot plastic instantly fills every tiny microscopic corner, completely forming the delicate locking tabs, the thin wire slots, and the outer alignment guide rails. Within just a few short seconds, freezing cold liquid water runs rapidly through hidden channels deeply inside the solid steel mold, instantly freezing the extremely hot plastic back into a totally solid, hard shape. The giant steel blocks suddenly pull far apart, and a physically brand new Automotive Housing for Female Terminals drops safely onto a moving conveyor belt. The machines run this highly loud cycle perfectly twenty-four hours a day. Because the physical tolerances inside a car's wiring system are so incredibly tight, the metal mold must be machined to absolute perfection. If it is flawed, the metal pins will never fit the Automotive Housing for Female Terminals correctly on the assembly line.